Beiter Thread Cylinder

Zoom image

89,00 CHF

8 % VAT incl. excl. Shipping costs

Shipping time: some Items in stock

Product no.: 334.3041.30

For further information, please visit the homepage of this product.

Excution:

Stock:

Excution						Stock:

5/16"long 61.5mm						1
M10x1 short = 53.5mm						1
M8x0.75 - long = 61.5mm						1

Details
Customer-tip

Beiter Thread Cylinder

Each single Plunger has a 3 to 4mm variable screw
length"A".
By changing single parts of it - Pin and/or slotted
nut and/or thread cylinder - a screw-in length from
17.5 mm up to 34.5 mm can be reached.
The available combinations are shown on the table
on the previous page

HINTS AND MAIN FEATURES:
The Beiter Plunger has a"hard"spring mounted (0.60 mm thickness).
If during the tuning of your bow the notching scale cylinder goes close to 0 on the thread scale,
change to the"extra hard"spring (0.70 mm thickness). This usually occurs if the arrow reacts too
weak.
If the thread scale goes close to 10, then replace the"hard"spring with the"soft"spring (0.45mm
thickness). This usually occurs if the arrow reacts too stiff.
Following table - included in each sold Plunger - shows how the single springs are reacting: with the
hard spring (0.60) on scale position 1.0 you will reach a tensile strength of approx. 8N (Newton).
You can reach the same tensile strength with an extra hard spring (0.70) on scale position 7.5.
Important: A wrong arrow (an arrow with the wrong spine) cannot be compensated by any
plunger!